Wheelhorse 520 H/ transmission oil

[Jose 11]

Hi I’m just wondering if somebody can help me out with a confused topic on transmission oil.some say 10W-30 which in my opinion is a motor oil which probably would work obviously but would 20 W 50 be the best??

[Achto 27,571]

5 minutes ago, Jose said:

some say 10W-30 which in my opinion is a motor oil which probably would work obviously but would 20 W 50 be the best??

 

A 520H is a hydrostatic drive transmission. The hydraulic oil also lubricates the axles, 20w-50 is too thick for the system to work properly. The correct oil recommended by   is 10w-30.

Edited June 8, 2022 by Achto

[Jose 11]

Awesome great appreciate that one more question so 100% synthetic would be the best? Thank you

[JoeM 7,874]

This is what Eaton Calls for in their manual for oils.

I prefer the antiwear oil like International HyTran. Matches the application for wear/shear additives. It is 10W30 viscosity. 

But keep in mind, 10w-30 motor oil has worked for years.

 

[Jose 11]

Good to know much appreciate! 

[Achto 27,571]

11 minutes ago, Jose said:

one more question so 100% synthetic would be the best?

 

 No problem using synthetic many of us use Mobil 1. 

 

Suggested filter is Wixx 51410

[WHX?? 48,815]

Some of the guys here report better cold weather operation with synthetic so that's what I run in my snow tractors. Not sure if it helps but can't hurt. 

[lynnmor 7,305]

Any 10W-30 motor oil will be fine.  I use Castrol semi-synthetic High Mileage oil and can tell a difference.

[roadapples 6,983]

[Ed Kennell 38,170]

   to the     Jose.

 

I use 10W30  semi synthetic in my three Eaton 1100 hydros and have never had a problem.         

 

Just a reminder,  Eaton recommends a 5-10 minute warm up for the 1100s.     Two of my lifts respond on start up and one requires a 10 minute warm up in the cold winter months.