davec101 0 #1 Posted February 3, 2022 New to the group. I have a 06-42ST02 snow thrower and the auger bearings are shot. For the life of me, I cannot figure out how to get the auger shaft out. Searched this forum but had no luck. Any suggestions? Share this post Link to post Share on other sites
roadapples 6,983 #2 Posted February 3, 2022 . Sorry I can't help. Someone will be along soon Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,036 #3 Posted February 3, 2022 You have to drive it out. I would stand the housing on it's end blocked up so there is a bit of room for the shaft to move. Keep the blocking close to the shaft. Get a big hammer and one or two hard swings should break it loose. A small hammer and tap tap is a waste of time. 2 Share this post Link to post Share on other sites
davec101 0 #4 Posted February 4, 2022 Great, thank you! Share this post Link to post Share on other sites
