41chevy 74 #1 Posted December 3, 2021 Good evening, I”m working on a 65-36xR01 rear discharge deck. I’m not sure if the spindles are original. I would like to know if the bearings are replaceable and if they are where do I start, I soaked them for a couple days and then gave them a few taps with a-brass hammer and nothing is moving. I don’t want to put them in the press till you guys give me some advice. These don’t have grease fittings, not sure if stock does. Thx Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,036 #2 Posted December 3, 2021 Click on the fuzzy picture in the link and on the next page are the original and replacement spindle assemblies. If you have D it is still available from aftermarket suppliers but not Toro. 1 Share this post Link to post Share on other sites
41chevy 74 #3 Posted December 4, 2021 Thank you, the info was very helpful. This is only my 2nd restoration, the 1st one I didn’t take completely apart, a B100. Now that I have the 100 done I decided to fillet this 80 and I’ll know how to put it back together copying the 100.😀😀😀 2 Share this post Link to post Share on other sites
