Flip scrapper blade

[CCW 1,292]

The scrapper blade on my 312-8's plow is worn on the outside corners from years of my father plowing the driveway.  The top edge is still original.  Can it be flipped over?

 

 

ccwpost

Edited September 5, 2021 by CCW

[pfrederi 17,680]

Yes!!

[stevasaurus 22,711]

Absolutely !!  In fact, I just happen to be doing that to my snow blade on my 857.  Rather then mess with the old rusted bolts, I used a 4" grinder and made quick work of those old bolts.  I also am changing from carriage bolts, I am using 1" X 3/8" stove bolts (they have a slot screw driver head) and Ny=Loc nuts.  Orientate the scalp blade so the worn angle is high against the snow blade...or grind the sharp edge smooth.  I'll take some pictures.  

[DougC 2,641]

I flipped mine over a few years ago when I noticed how worn it was getting.Used my 1/2 inch impact and zipped off the nuts. The carriage bolts didn't spin at all so reused all the original fasteners. 

I should mention it was a 520H dozer blade.

 

Edited September 5, 2021 by DougC

[SylvanLakeWH 25,501]

Yes

 

Just did one of mine. Stainless bolts…

 

Easy peasy…

[CCW 1,292]

Thanks all.  The WH is not used for plowing snow, but I do need to move topsoil.

 

[stevasaurus 22,711]

Mine was rusty like yours.  It would not let the snow go when pushing it.  I used a 4" grinder with a wire wheel, cleaned off the rust, primed with Rust Oleum red primer.  I used a 3" roller and Regal Red in a qt can along with a brush to paint.  Painted the scraper flat black a flipped over.  Pictures...