B80 won’t turn over

[Felix 145]

Gone from bad to worse. I had one running tractor and one dead one. Now both are dead. 
I tried to start the old c120 I’ve acquired and couldn’t get a spark. I fitted a new coil and still nothing. so I put the new coil on the running B80 I have to test it and it turned over a few times and then stopped. Now it won’t turn over at all. Could this be coincidence or have I blown something. Any ideas any body? 
 

[squonk 41,153]

If that B-80 has an ammeter, check the connections there.

[pfrederi 17,741]

Coil would not prevent cranking.  Check all your connections may have yanked something loose during the swap.

[Felix 145]

4 minutes ago, squonk said:

If that B-80 has an ammeter, check the connections there.

No there’s no ammeter on it. It started to crank with the new coil then suddenly stopped and I’d now there’s nothing. 
it’s never done this before. I was wondering if I got the wrong coil and it’s somehow blown something. 

[oldlineman 1,481]

I don't have experience with the B-80 but may be a blown fuse if there is one on that model. Bob

[Gregor 4,846]

3 hours ago, Felix said:

 I was wondering if I got the wrong coil and it’s somehow blown something. 

The ignition circuit, and the starter circuit are completely separate. At least they are suppose to be. One has nothing to do with the other.

[rmaynard 15,514]

Check your safety switches.

Edited July 17, 2021 by rmaynard

[Felix 145]

Problem solved. A wire had come of pto safety switch 

thanks everyone 👍🏻👍🏻👍🏻

[Tuneup 1,433]

3 hours ago, Felix said:

Problem solved. A wire had come of pto safety switch 

thanks everyone 👍🏻👍🏻👍🏻

Hey Felix - your Wheel Horse is speaking to you. One wire fell off meaning the other wires are about to do so. Time to take a close look at the wiring on that old machine.