Stubby 19 #1 Posted June 27, 2021 Trying to grease spindles and grease is not appear to be going down in the housing. It comes out between the pulleys and the deck. What is the failure? I am thinking it is the shaft not allowing grease down. So putting new bearings in would be useless. Please advise. Share this post Link to post Share on other sites
squonk 41,040 #2 Posted June 27, 2021 You probably have hardened grease in the bearings not allowing the new grease to travel. Tear down and new bearings should solve it. 1 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,033 #3 Posted June 28, 2021 There was a problem later on. Garry 1 Share this post Link to post Share on other sites
Stubby 19 #4 Posted June 28, 2021 that is ok, I am having a problem getting one of the outside pulleys off. The two on the ends are the same, but even with a puller it is not being my friend. pulley is bent to heck and it is not budging. SMH. Share this post Link to post Share on other sites
Jeff-C175 7,199 #5 Posted June 28, 2021 12 minutes ago, Stubby said: pulley is bent to heck Make sure you're sitting down when you price a new pulley! 1 Share this post Link to post Share on other sites
Stubby 19 #6 Posted June 28, 2021 yeah pretty expensive. heck it dont matter until I get this one off. Dont want to cut it off if possible. 1 Share this post Link to post Share on other sites
