chev0545 234 #1 Posted April 25, 2021 have a hub that i can't get off.what's a good puller? thanks Share this post Link to post Share on other sites
ebinmaine 67,619 #2 Posted April 25, 2021 (edited) Believe it or not the Best puller is actually another hub. Do NOT use a 3 jaw. @953 nut has shared a pic or two of hub puller that's done with threaded rod and a jack. Edited April 25, 2021 by ebinmaine Added word 1 1 Share this post Link to post Share on other sites
ebinmaine 67,619 #3 Posted April 25, 2021 Scroll down a bit in this thread and there's a few great puller ideas. I've put a few "search words" in it so I can find it when I need to. 2 Share this post Link to post Share on other sites
peter lena 8,634 #4 Posted April 25, 2021 ebin , agree with you on the use of another hub , the most important thing of a long stuck part removal , is OVERWHEMING SOLID STRENGTH , when its hooked up correctly , its just a solid steady pull off , steering wheel removal is a good example of that . when that steering shaft is bouncing , you are going nowhere . when you brace it up to a wall or post , the mechanical pull is solid and smooth . learned from failure , pete 2 Share this post Link to post Share on other sites
squonk 41,155 #5 Posted April 25, 2021 (edited) Homemade. 3/4" plate. 7/8"fine thread HD all thread and 3 HD 7/8" fine nuts. 5 7/16" fine bolts threaded into the hub with washers and nuts backing them up. (backing nuts not pictured) Edited April 25, 2021 by squonk 6 Share this post Link to post Share on other sites
Maxwell-8 4,277 #6 Posted April 25, 2021 And don't use the existing bolt-treads in the stuck hub (don't ask me how i know ) Share this post Link to post Share on other sites
daveoman1966 3,752 #7 Posted April 25, 2021 This has never failed me... While you have it off, check the seal...good time to replace it too. 1 Share this post Link to post Share on other sites
ebinmaine 67,619 #8 Posted April 25, 2021 1 hour ago, daveoman1966 said: This...... EXCELLENT set of instructions Dave. How big of a dead blow do you have? I've had a 1# until recently then added a 3# to the arsenal. Share this post Link to post Share on other sites
Jeff-C175 7,202 #9 Posted April 26, 2021 1 hour ago, daveoman1966 said: to replace it I've always used the hub as a 'slide hammer' to seat the seal straight and true. Works good for me! 1 Share this post Link to post Share on other sites
