Kevinm 23 #1 Posted December 26, 2020 Is there a particulr gap setting for the bracket relative to the PTO pulley. I just replaced mine, becuase the pad was was worn down to the rivets. Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,187 #2 Posted December 26, 2020 Stick a business card between the pad and the pulley and apply the pto. Hold pad tight to the card and tighten the bolts that mount the pad. Release the pto and remove the business card. 4 1 Share this post Link to post Share on other sites
Handy Don 13,131 #4 Posted December 26, 2020 (edited) 4 hours ago, gwest_ca said: Stick a business card between the pad and the pulley and apply the pto. Hold pad tight to the card and tighten the bolts that mount the pad. Release the pto and remove the business card. I found that a bit tight (the book calls for .15") so I use two cards! Edited December 26, 2020 by Handy Don 1 Share this post Link to post Share on other sites
