formariz 11,988 #26 Posted January 2, 2021 2 hours ago, Mickwhitt said: I tried Fred this morning and he ran a bit lumpy at high speed, so obviously not enough fuel due to there being only two holes in the needle. So I drilled two new holes 25 thou diameter and opened up the lower hole to 1/32nd as advised on pulling tractor site. Immediately the difference was clear. Ticking over smoothly and instant response to opening the throttle. I can adjust the fast jet too as I said so it seems I've made a big step forward. Next job is to make a new tapered tip from brass for the damaged needle and graft it on to see if I can rescue it. As I said before I follow advice from that site religiously and it has always paid off. Lots to learn from reading carefully through it. It is just too bad that he seems to be so unreliable when it comes to doing business. I am glad things are working out for you. Share this post Link to post Share on other sites
Tom kite 3 #27 Posted January 10, 2021 On 12/20/2020 at 5:00 PM, richmondred01 said: Why do you think it needs to be rebuilt? whats the compression gauge read? 100. Share this post Link to post Share on other sites
lynnmor 7,321 #28 Posted January 10, 2021 4 minutes ago, Tom kite said: 100. Run it. Share this post Link to post Share on other sites
