JoeM 7,874 #1 Posted November 21, 2020 Looking through the archives, I found this pic were I straighten a bent lift cylinder rod this summer. Worked out okay. Thought I would share. 7 2 4 Share this post Link to post Share on other sites
Pullstart 63,203 #2 Posted November 21, 2020 Great work Joe! I can’t imagine what would bend it, but good stuff! Share this post Link to post Share on other sites
ebinmaine 68,885 #3 Posted November 21, 2020 Nice work Sir Share this post Link to post Share on other sites
JoeM 7,874 #4 Posted November 21, 2020 1 hour ago, pullstart said: I can’t imagine what would bend it Me also....just figured the PO ran over something and it pushed up on the shaft??? 1 Share this post Link to post Share on other sites
Pullstart 63,203 #5 Posted November 21, 2020 23 minutes ago, JoeM said: Me also....just figured the PO ran over something and it pushed up on the shaft??? was it on the XI? Share this post Link to post Share on other sites
JoeM 7,874 #6 Posted November 21, 2020 No on a old c141 1 Share this post Link to post Share on other sites
