How does a Kohler 14hp attach to raider frame?

[Zednoug 56]

I have a 1972 raider 14 that I am restoring but I cant figure out how the engine attaches to the frame, parts manuals show an engine plate but dont show how tall it is.

Edited November 8, 2020 by Zednoug

[Ed Kennell 39,460]

All the Kohlers I have use two bolts and nuts on the left side and two bolts inside the right frame rail into two tapped holes in the oil pan plate.

The only plates I am aware of are the rocker plate engine mounts.

[rmaynard 15,767]

18 hours ago, Ed Kennell said:

The only plates I am aware of are the rocker plate engine mounts.

I know that the K-181's sat on a plate on mid/long frames, and that is shown in many of the parts diagrams. 

Edited November 9, 2020 by rmaynard

[953 nut 56,395]

You may have small base Kohler which will require a mounting plate. Take a look at this thread to see which you have.

 

[The Tuul Crib 7,338]

16 hours ago, Ed Kennell said:

All the Kohlers I have use two bolts and nuts on the left side and two bolts inside the right frame rail into two tapped holes in the oil pan plate.

The only plates I am aware of are the rocker plate engine mounts.

[The Tuul Crib 7,338]

T😎

[Zednoug 56]

On 11/9/2020 at 6:44 AM, The Tuul Crib said:

T😎

 

[clueless 3,027]

So is the 14 hp the original engine the came on it? Second did you disassemble the tractor to restore it?

[Zednoug 56]

Just now, clueless said:

So is the 14 hp the original engine the came on it? Second did you disassemble the tractor to restore it?

Yes the engine is the original but it sat for a while in my scrap pile without the engine and and trans axle attached.