Goofball65 13 #1 Posted November 7, 2020 putting my 856 back together but have dilema when i took frame off rear there was no detent ball/spring and pin in the spot the pic shows they go. do they go in from outside or are they inside and if outside ? holds them in ? the frame? dumbfounded/ brainfart ! feel stupid but can anyone help ? Share this post Link to post Share on other sites
WHX?? 49,158 #2 Posted November 7, 2020 They go in from outside when installing the shift rails. Procedure is in manual and @stevasaurus has video on how to. 2 1 Share this post Link to post Share on other sites
peter lena 8,721 #3 Posted November 7, 2020 GOOFBALL, agree with above on installation, most important is , DO NOT ROUGH HOUSE OR FORCE THIS SCREW IN , its a simple snug into place. is your transmission clean and fresh oil ? there are a series of operational checks and shifting that go with this. you can drive and use every gear and hi/lo range , to verify its operation . get some hours of operation on it , is oil getting dirty ? flush it out , refill and do it again , you are trying to recover this , is your clutch linkage LUBRICATED , AND FREE AND EASY WORKING ? let us know , pete 1 1 Share this post Link to post Share on other sites
stevasaurus 22,863 #4 Posted November 7, 2020 Check out this video from about .30 sec. 1 1 Share this post Link to post Share on other sites
The Tuul Crib 7,337 #5 Posted November 8, 2020 And y'all forgot to mention one thing lots of patients! do not lose the balls! 2 Share this post Link to post Share on other sites
Goofball65 13 #6 Posted November 8, 2020 Thanks guys ! that was what i needed, had a brain fart , she shifts and stays in gear . 2 Share this post Link to post Share on other sites
