bc.gold 3,403 #30 Posted August 30, 2020 The hammer mill does an excellent job recovering fine copper wire, as an experiment made three copper briquettes. Share this post Link to post Share on other sites
bc.gold 3,403 #31 Posted August 30, 2020 Went to Jack's scrap yard. in hopes of finding a 12 volt Prestolite starter to fit and convert my Case over to a 12 volt system, no luck on the starter but did find a decent 12 volt generator with regulator. While at Jack's yard got a few copper ends from evaporators in which I'll recover the silver ,ending up with pure copper sheet. Then there was this linear device that would make a good 3 point lift for a small tractor. Share this post Link to post Share on other sites
