Magnum starter removal not done one yet!

[The Tuul Crib 7,338]

Sitting here looking at the starter on this magnum and trying to figure out the best way to remove it without well you know screw it up!? I need a push!

[pfrederi 18,090]

Tape the end caps to the body.  the two mounting screw also hold the ends on

Edited June 28, 2020 by pfrederi

[stevasaurus 22,959]

Can you remove the bracket with the starter attached so you can get it on the work bench before taking out those through bolts??

 

Careful, there is a spring snake in the case!!    

 

[WVHillbilly520H 10,374]

1 hour ago, The Tuul Crib said:

Sitting here looking at the starter on this magnum and trying to figure out the best way to remove it without well you know screw it up!? I need a push!

I just did the 414-8... Take the dipstick tube off (3 screws) then remove the block fastening bolts easy peasy installation is in reverse operation.

[The Tuul Crib 7,338]

1 minute ago, WVHillbilly520H said:

I just did the 414-8... Take the dipstick tube off (3 screws) then remove the block fastening bolts easy peasy installation is in reverse operation.

I just picked this engine up from a friend he said he didn't need it no more so he gave it to me. I have a magnum 14 but I have never pulled a starter off of it so I was making sure I didn't turn something that wasn't supposed to be turned!

[The Tuul Crib 7,338]

3 minutes ago, WVHillbilly520H said:

I just did the 414-8... Take the dipstick tube off (3 screws) then remove the block fastening bolts easy peasy installation is in reverse operation.

Man that sounds too much like a day job!! Ill give it a try ! I'm actually gonna set it back aside so I can get back to my sunstrand rebuild. 

[WVHillbilly520H 10,374]

Just now, The Tuul Crib said:

Man that sounds too much like a day job!! Ill give it a try ! I'm actually gonna set it back aside so I can get back to my sunstrand rebuild. 

Day job yes... 10 mins... And the rest of the day for some malted adult beverages of your choice 😁.