Back in the shop for more repairs!

[The Tuul Crib 7,338]

So Irv is back in the shop for more repairs someone's knocking at the door or in this case the oil pan. Going back to the 14 horse that got gas in it the last time because of the fuel pump. Hope it's quick this is a great cutting tractor ! I took two cranks  to my machine shop friend at the 

tune of a whopping 80 bucks! I'm taking a 16 horse block with me that has been bored 20 over and thinking about going to 30 with it. Any thoughts?

[ebinmaine 68,885]

1 hour ago, The Tuul Crib said:

16 horse block with me that has been bored 20 over and thinking about going to 30 with it. Any thoughts

It is usable at .020?

 

Leave it alone if so.

No real gain in an increase of .010. 

[The Tuul Crib 7,338]

2 hours ago, ebinmaine said:

It is usable at .020?

 

Leave it alone if so.

No real gain in an increase of .010. 

Well the piston that was in it when the rod blew was 20 over. I'm not sure what the PO did to the motor but he was using it for pulling. Have been told you can go to 30 if you're not pulling maybe someone correct me if I'm wrong. He's going to check with the dial board gauge see what's going on with the cylinder and check the piston out as well. If they're fine I'll just do a hone job and new rings.

[The Tuul Crib 7,338]

Yesterday got some things together. Picked up the two cranks from the

machine shop.  One for this one and 

one for my k341 build later. Hope to 

having this running this weekend.

Edited June 27, 2020 by The Tuul Crib

[The Tuul Crib 7,338]

The 14 is on!

Edited June 27, 2020 by The Tuul Crib

[The Tuul Crib 7,338]

Done !! Back and running ! 
Two cranks it popped right off!! 
Sounds like a Kohler!!