pfrederi 17,867 #26 Posted April 29, 2020 7 minutes ago, d200 :) said: Ok copling engine and pump is ok. I used thin layer of paste behind the gasket dont remeber the number on oil filter but bougth it from toro. I wil try pressure test thank you for info Be very careful about sealants on hydros especially the silicone stuff. i will not use it on them. There are some very small passages in a hydro and i have found bits of blue stuff in them. Toro filter is OK some aftermarket one do not perform correctly. You will need an SAE #6 ORB (O-Ring Boss) fitting for the pressure test . Share this post Link to post Share on other sites
d200 :) 1 #27 Posted May 4, 2020 Hi found out what was wrong. Was the swash plate was not in place. Now it works great again thanks for all the tips Share this post Link to post Share on other sites
d200 :) 1 #28 Posted May 4, 2020 So now start rust jobb and paint Share this post Link to post Share on other sites
