Adding hydraulic lift to Charger 9

[kto434 108]

Is it possible to add hydraulic lift to a Charger 9 (has a Sundstrand tranny)?  If so, is it a difficult conversion and any idea of the parts needed and approximate cost.  Thanks!

[pfrederi 17,886]

Not difficult.  You need a cylinder. control valve, some hoses and an implement relief valve (spring and cone valve). cylinder valve and relief check with A-Z tractors in vendors section hoses wheel horse man also in vendors section.

[daveoman1966 3,762]

To add Hyd LIFT to the Charger 9, you need LIFT KIT # 8-4111.  Here is a schematic of that kit with parts listed...most are no longer available.  However, I have those parts marked in RED.  

I don't have the Hyd Cylinder 6618 (item # 3) or the Bell Crank (item # 1) but the others...yes.  

Myu direct email is:

daveoman@windstream.net.

The cylinder 6618 is in this pic as A and B is the replacement for it, which is rebuildable...A is not unless to cut it open.

  

HYD KIT 8-4111.xlsx