Jump to content

 
Countdown To Christmas!
 

 
The Tuul Crib

Transmission re assembly

Recommended Posts

The Tuul Crib

I'm about to put this transmission together and I have a question. While putting together all the parts inside as I do will it hurt to apply a light amount of grease to the needle bearings and some of the shafts on the inside?

  • Like 1

Share this post


Link to post
Share on other sites
 
cleat

I would think that would be fine.

 

Some old transmissions with loose needle bearings you have to grease them to stay in place during assembly.

 

The gear oil will mix with the grease and you will never know it was there.

 

Cleat

 

 

  • Like 3
  • Excellent 1

Share this post


Link to post
Share on other sites
 
ebinmaine

I just used a couple drops of gear oil on them to help ease the pieces in place

  • Like 2

Share this post


Link to post
Share on other sites
 
953 nut

:text-yeahthat:      Gear oil is what they live in.

  • Like 1

Share this post


Link to post
Share on other sites
 
pfrederi

For gear trannies grease or gear oil would be OK However for a hydro transaxle that is going to run ATF I would just use ATF on the bearings.  if you are going to use 10w-30 then I suppose grease would be OK.

  • Like 1

Share this post


Link to post
Share on other sites
 
WHNJ701

what's that "pink" stuff called?  I see it used alot in rebuilds of trans, rears, other gears

Share this post


Link to post
Share on other sites
 
The Tuul Crib

Not really sure but some one might 

Share this post


Link to post
Share on other sites
 
McGrew

Jabelman,  I bet you are talking about Red Line Shockproof gear oil.  It is what I run in my Harley trans.  It looks like Pepto Bismol and sticks to gears like glue.  Great stuff, but definitely not cheap!  Danny

  • Like 1

Share this post


Link to post
Share on other sites
 
stevasaurus

I don't think I would pack a lot of grease in the bearings.  remember the oil has to get through some of the bearings to get to the ones on the out end.  Outer axle bearings and the outer input bearing.  I would just soak in the 90wt for a minute or two.  :occasion-xmas:

  • Like 2
  • Excellent 1

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
  • Create New...