Paul Boy 31 #1 Posted October 20, 2018 (edited) I have tried to route a new chain on my snowblower. As far as I can tell its an STR 324 and goes on a 67 lawn ranger. Its 32 inches wide and appears to be all intact. Just cannot get that chain on. Any suggestions? Edited October 20, 2018 by Paul Boy Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,033 #2 Posted October 20, 2018 Guessing what the problem is. The chain does not go around the sprocket on the auger. If it did it would turn in the wrong direction. It just goes past it. The chain goes directly to the idler sprocket and back to the sprocket on the drive shaft. Am I correct? Garry Share this post Link to post Share on other sites
Paul Boy 31 #3 Posted October 20, 2018 Would anyone have a diagram handy? Share this post Link to post Share on other sites
pfrederi 17,669 #4 Posted October 21, 2018 Goes under the auger sprocket around the idler and back to drive Share this post Link to post Share on other sites
Paul Boy 31 #5 Posted October 22, 2018 Its possible that I am missing a part. I just cannot seem to make this blower operate. I have another blower on my C161 so I am kind of going by that one. Share this post Link to post Share on other sites
pfrederi 17,669 #6 Posted October 22, 2018 Here re some pics of when i had mine on the L-107 See anything different from yours? What isn't working... Share this post Link to post Share on other sites
Paul Boy 31 #7 Posted October 23, 2018 Good pictures, thanks. I think I see my problem. Will try again tomorrow if the rain holds off. Share this post Link to post Share on other sites
