mc1960 43 #1 Posted August 31, 2018 Getting ready for a Fall garden, tractor is ready, need help setting up plows to make rows etc can not find what I am looking for on youtube. Any ideas would be much appreciated. Mark Share this post Link to post Share on other sites
953 nut 55,081 #2 Posted September 1, 2018 If I remember correctly there was a post by @PeacemakerJack or @WHX20 on this a few months back. Share this post Link to post Share on other sites
Tankman 3,518 #3 Posted September 2, 2018 Be sure to have front weight. My first plow, wheels off the ground. Fab’d a front bumper, added suitcase weights. Share this post Link to post Share on other sites
WVHillbilly520H 10,373 #4 Posted September 2, 2018 57 minutes ago, Tankman said: Be sure to have front weight. My first plow, wheels off the ground. Fab’d a front bumper, added suitcase weights. Hopefully you already have the rear sleeve/clevis/slot hitch, and the Brinley moldboard plow, the rest really is trial and error, but there is a video or 2 of properly setting up the tractor and plow on YouTube I have viewed them myself, you can also download the Brinley plow owner's manual from Brinley's site, Jeff. 3 Share this post Link to post Share on other sites
Daron1965 644 #5 Posted September 2, 2018 6 hours ago, Tankman said: Fab’d a front bumper, added suitcase weights. How did you make the bumper? Looks great. Share this post Link to post Share on other sites
Daron1965 644 #6 Posted September 2, 2018 Just installed my plow today for the first time. It's a 10 inch plow, so I lifted the left side 5 inches and then adjusted plow. 3 Share this post Link to post Share on other sites
Tankman 3,518 #7 Posted September 2, 2018 3 minutes ago, Daron1965 said: How did you make the bumper? Looks great. Fab’d 10 ga CRS, welded. Bolted to existing frame bolt holes. Pic is a son, 40 years ago, 1 Share this post Link to post Share on other sites
WVHillbilly520H 10,373 #8 Posted September 2, 2018 1 hour ago, Daron1965 said: How did you make the bumper? Looks great. Here's my blue prints... I don't have ability to make anymore, but a decent machine shop shouldn't have any problems. 2 1 Share this post Link to post Share on other sites
Daron1965 644 #9 Posted September 3, 2018 Great info. Thank you 1 Share this post Link to post Share on other sites
