-
Similar Content
-
By RJ Hamner
Started tearing down the engine on my 68 Raider and first noticed the piston was stamped with an "A".
As I cleaned off the top of the block I noticed that the block had been also stamped with an "A" between the intake and exhaust valves.
Is this something done at the factory? Or when it may have been serviced? or????
Believe it or not the bore is still within limits which I found as odd. But when I broke down the transmission it was like new????
Any ideas?
Bob
-
By oe espo
Just got my #26 Carburetor from a notable carburetor builder for my K301S. Tractor still doing what it did before. Major power loss under load and especially up hill. at a loss here. lots of hours on it. I didn't check compression yet Any suggestions appreciated.
-
By Jim Slaaen
The front-bearing on my el-starter to my C-120 1974, is somehow gone. Else the starter is fine. Is there possible to get a replacement bearing?
-
