Wheelie horse 90 #1 Posted May 28, 2018 Was cutting the grass today with my 416-8 I went to switch from 2nd to first gear and then it would not move and the shifter had no tension in it almost as if it was broken you could move it into any gear without clutch and nothing would happen. If anyone can help that would be great what could this be Share this post Link to post Share on other sites
Irv 115 #2 Posted May 28, 2018 set screw (dog point) either loose or broken. Take off shifter plate and raise boot and you'll see. 4 Share this post Link to post Share on other sites
Cee245 818 #3 Posted May 28, 2018 Ugh Sorry to be bearer of bad news but you might need a new shift fork and other parts for that uni drive.. You will probably have to open up the transmission. I have rebuilt my dad's and it isn't too complicated if you have a little know how. Good luck to you. Cory Share this post Link to post Share on other sites
Cee245 818 #4 Posted May 28, 2018 Right. @Irv. And make sure to replace the shift boot when making any transmission work. Share this post Link to post Share on other sites
ericj 1,578 #5 Posted May 29, 2018 check and make sure you didn't knock the high low range shifter in neutral, don't ask me how I know this eric j 2 2 1 Share this post Link to post Share on other sites
Pollack Pete 2,273 #6 Posted May 29, 2018 9 hours ago, ericj said: check and make sure you didn't knock the high low range shifter in neutral, don't ask me how I know this eric j Duh.....did this just this past Saturday on my 414-8.Mowed about 10 feet and the tractor stopped moving.Pushed it back to my shop,pulled of the right foot rest and drive belt cover.Belt was real loose,but not bad enough to make the tractor not move at all.Thought something broke in the tranny.Standing there looking and feeling stupid,I glanced at the hi lo shifter.It was in neutral.What a relief.Installed a new #7473 belt that I already had.Goes like new now.Belt should last another 30 yrs.Good luck with your problem. 5 Share this post Link to post Share on other sites
slovenc0417 3 #7 Posted August 25, 2019 On 5/28/2018 at 9:27 PM, ericj said: check and make sure you didn't knock the high low range shifter in neutral, don't ask me how I know this eric j Oh what a relief! My brother was visiting for the week and wanted help around the house so we gave him a quick tutorial on how to operate our Wheel Horse. He cut about 80% and all of a sudden it wouldn't move. "So what did you do?" "I dunno?" Now we know! Oh what a relief! 1 1 Share this post Link to post Share on other sites
953 nut 55,787 #8 Posted August 25, 2019 8 hours ago, slovenc0417 said: we gave him a quick tutorial on how to operate our Wheel Horse. Glad you were able to solve the problem. Please do an introduction and tell us about yourself and your . https://www.wheelhorseforum.com/forum/47-introductions/ Share this post Link to post Share on other sites
