Bill Sherman 11 #1 Posted May 2, 2018 The rubber footrest pads on both of my tractors are deteriorated. Does anybody have any suggestions of what works best as a replacement material? Thank you very much. Share this post Link to post Share on other sites
oliver2-44 9,787 #2 Posted May 2, 2018 Skate Board grip material, or truck bed liner. There was a vendor on here, but I don't see them. Maybe some one else can point you to them. Share this post Link to post Share on other sites
Racinbob 11,115 #3 Posted May 2, 2018 Don't know what models you have but this outfit might help. http://www.classickitchensandmore.com/wheel-horse-tractors-parts-c-42.html 4 Share this post Link to post Share on other sites
Bill Sherman 11 #4 Posted May 2, 2018 Thank you very much! Share this post Link to post Share on other sites
TDF5G 2,069 #5 Posted May 4, 2018 I found these at Lowes or Home Depot and cut down to match the factory ones. Looks original. 2 Share this post Link to post Share on other sites
Tankman 3,518 #6 Posted May 5, 2018 (edited) On 5/2/2018 at 2:26 PM, oliver2-44 said: Skate Board grip material, or truck bed liner. There was a vendor on here, but I don't see them. Maybe some one else can point you to them. Been using, sons idea, coarse grip skateboard tape for years. Never fails. I use a paper cutter for nice clean cuts. One piece does both foot rests. Inexpensive too! https://www.skatewarehouse.com/Bullet_Griptape/descpage-BU9GRIP.html Edited May 5, 2018 by Tankman 2 Share this post Link to post Share on other sites
manahale 43 #7 Posted September 15 Thanks for the tip Tankman. Should arrive tomorrow. Share this post Link to post Share on other sites
