CountryRock 199 #1 Posted May 12, 2017 I picked up an early 90s Wheel Horse 246H yesterday. It has a 38 inch deck on it. Looking for as much info as possible on it. Thanks. 9 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,176 #2 Posted May 12, 2017 Have a model number and serial number off the data decal? Looks like it can be seen under the left side of the seat. Garry 1 Share this post Link to post Share on other sites
CountryRock 199 #3 Posted May 12, 2017 I'll have to get it when I get home from work after midnight. Share this post Link to post Share on other sites
JERSEYHAWG / Glenn 4,498 #4 Posted May 12, 2017 to the club. Glenn Share this post Link to post Share on other sites
CountryRock 199 #8 Posted May 13, 2017 I appreciate all the welcomes. The model is 4216BE01. Serial 2000142. Share this post Link to post Share on other sites
tims tractors 119 #9 Posted May 13, 2017 I,m sure I speak for many glad to have ya. Tim 1 Share this post Link to post Share on other sites
Retired Wrencher 5,589 #10 Posted May 13, 2017 CountryRock You will find a lot of info here. Good luck and enjoy the ride. 1 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,176 #11 Posted May 13, 2017 Garry 5 Share this post Link to post Share on other sites
CountryRock 199 #12 Posted May 13, 2017 Thank You. 1 Share this post Link to post Share on other sites
953 nut 56,729 #13 Posted May 13, 2017 Garry hooked you up with lots of good reading material, enjoy your 1 Share this post Link to post Share on other sites
Tankman 3,520 #14 Posted May 14, 2017 Garry must be a Horse. Never misses! 2 Share this post Link to post Share on other sites
jay bee 912 #15 Posted May 14, 2017 to the Country Rock!!! Jim 1 Share this post Link to post Share on other sites
CountryRock 199 #16 Posted May 16, 2017 I pulled the deck off today. I'll be tinkering with things this week and the weekend. Need to adjust the PTO clutch on it and clean the underside. Also going to clean all the zerk fittings and give it a good greasing. Then I'll fiddle with the deck adjustments to set it where I need it. 1 Share this post Link to post Share on other sites
elliot ness 1,916 #17 Posted May 16, 2017 Welcome to Red Square, where a world of knowledge about these wonderful Wheel Horses is yours just for the asking. 2 Share this post Link to post Share on other sites
CountryRock 199 #18 Posted June 2, 2017 Got the deck fixed up decent enough and reinstalled it. Seems to cut fairly well. I'll be looking for either a new deck pan to rebuild this one on eventually or a slightly larger 42 inch deck for this rig. I put a post up in the classifieds for that. I like this little wheel horse quite a bit. 1 Share this post Link to post Share on other sites
