Gunny 240 #1 Posted March 12, 2017 Dose anyone know the dimensions on the shift stop pin for a 5060 Trans? I have 3 pins all different lengths. This trans has been on the bench for about two years and finally have time to re-assemble. This is the only part I can't seem to identify. Would hate to put the wrong length pin in, then not be the right one. Thanks, Dennis Share this post Link to post Share on other sites
N3PUY 1,031 #2 Posted March 12, 2017 I have 2 transmissions apart and could measure it but I don't know what pin you need. How about a pic? Share this post Link to post Share on other sites
varosd 1,185 #3 Posted March 12, 2017 Hey Dennis! how is everything in TX? just think only a couple months to the Big show we are looking at 14 " of snow Monday night Share this post Link to post Share on other sites
Terry M-(Moderator) 2,176 #4 Posted March 12, 2017 He's talking about the pin between the detent balls. I looked at the 5060 download and the parts description on the Parts tree site....no measurements listed that I could see. Share this post Link to post Share on other sites
N3PUY 1,031 #5 Posted March 12, 2017 I went out and measured them ... both were 3/4" long. Share this post Link to post Share on other sites
Terry M-(Moderator) 2,176 #6 Posted March 12, 2017 1 minute ago, N3PUY said: I went out and measured them ... both were 3/4" long. 5060 ? Share this post Link to post Share on other sites
N3PUY 1,031 #7 Posted March 12, 2017 1 minute ago, Terry M said: 5060 ? No model tags on them. One is out of a 312-8. The other is from a 310-8. 1 Share this post Link to post Share on other sites
WHX?? 49,189 #8 Posted March 12, 2017 Yes 3/4 in, detent balls are .025 when they go flying 1 Share this post Link to post Share on other sites
N3PUY 1,031 #9 Posted March 13, 2017 34 minutes ago, WHX9 said: Yes 3/4 in, detent balls are .025 when they go flying I think you mean "the balls are .25". 2 Share this post Link to post Share on other sites
Gunny 240 #10 Posted March 13, 2017 Thanks all. As usual, about the time I hit the send button, I located the pin. It is 3/4 ". Just about have the tranny together now. Don, Too much snow for me. Left Anchorage last Saturday....about 2+ feet of snow, somewhere around 0 degrees. Got to Texas, about 75 degrees. I'll take Texas! I will be in Maryland most of June, have all plans of being at the show for Friday evening and Saturday. Looking forward to seeing everyone again. Dennis 3 Share this post Link to post Share on other sites
WHX?? 49,189 #11 Posted March 13, 2017 13 hours ago, N3PUY said: I think you mean "the balls are .25". Yes thank you N3 my bad... they still go rolling to the exact center of the garage where the floor drain is! Share this post Link to post Share on other sites
