Jump to content
Rpm76

Engine power loss

Recommended Posts

Rpm76

I have a C-161 twin auto with a 16hp Briggs. It's losses power when put under a load and sounds like it miss fires and shoots a flame out the  exhaust at high idle. I flashed the gas tank cleaned the fuel filter, cleaned the carb & rebuilt the fuel pump still the same problem. Any suggestions on where to look next ?  Thanks for any help I can get.  

 

Share this post


Link to post
Share on other sites
 
oldredrider

I'm betting you have a bad condenser. Try replacing it with a good one before anything else. They are inexpensive. 

  • Like 1

Share this post


Link to post
Share on other sites
 
woodchuckfarmer

Its a mag ignition , no condenser.  Look for a bad wire or a new set of spark plugs.     Wayne

Share this post


Link to post
Share on other sites
 
oldredrider

Wayne, you're correct.  I was hasty in the diagnosis.  I do agree it's an electrical problem.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • bigbuck
      By bigbuck
      I had a fire in 2019 which destroyed my pole barns and some wheel horse tractors and parts. i'm looking for someone who can use the engine that went thru the fire. It is not pristine but there must be some usable parts
      please call George at 517-499-5678 for more info.
    • davidfindlay
      By davidfindlay
      Looking to find a new home for my 84 (I think) C-145. It has a dump trailer with the enclosure for leaves, the PTO impeller to get the leafs into the trailer, the hoses for deck-to-impeller, impeller-to-trailer.
       
      I haven’t run it in over a year.
      The battery and the cable to the battery probably need to be replaced.
      Comes with a new head gasket still in the bag.
      Seat is cracked but still comfortable.
       
      Happy to answer questions or take other pictures.















    • cJ_3D
      By cJ_3D
      Hey all!
       
      Replacing the drive belt on my 252-h. Anyone know the torque specification for the center screw when I put this pto clutch back on? I know it was on there tight it took a minute for the impact to break it loose. Thanks!
       
      CJ

    • 87 416-8 horse
      By 87 416-8 horse
      I’m looking for wheel horse tractors for sale or for parts in the Eastern Nebraska or western Iowa area. Preferably 8 speed manuals. Pm me or comment with what you have. The worst I could say is it’s out of my price or distance range. Edit: engine is not important, it’s going to get an engine swap.
      Thanks,
      John
    • bkarp@roadrunner.com
      By bkarp@roadrunner.com
      my magnum 12 kohler all of a sudden is blowing oil out of the carb. if rings are bad should oil be blowing out of the muffler.thanks for any help brent
×
×
  • Create New...