Jump to content
Wayne123

1987 312-8 seat switch wiring positions on switch

Recommended Posts

Wayne123

I just purchased 312-8 .. I believe it's a 1987 as engine serial is 1987. Seat switch ....two of three seat switch wires were disconnected and warning light panel is out. Test switch activation shows no change when activated . I would like to reattach seat switch wires with the hope the dash test lights deactivate? I have an orange , black and light green but not sure which bayonettes on the switch to reattach them to. The black wire was attached to switch but may be on wrong batonette?

bayonettes on switch are labeled com, no and nc. The black wire was attached to "no " position  when I pulled out switch. I was wondering if anybody knew which color wires go on these designated positions on the switch? Thanks  

Share this post


Link to post
Share on other sites
 
gwest_ca

NO - light green

NC - orange

Com - black

 

The seat switch controls the ignition

 

Garry

  • Like 1

Share this post


Link to post
Share on other sites
 
Wayne123

Thank you Gary . I suspected that black should have have gone on com? 

Thanks again  I have a Raider 8 and just got this 312-8    Big difference ! 

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • Mattgray
      By Mattgray
      I am looking for a snow plow in the Western NC area, might be a long shot but iv checked marketplace and craigslist. No luck. if anyone has one or knows where I could get one. I believe I need a long frame one for my tractor. Thank you!! sorry if I posted this in the wrong spot. One year after owning my wheel horse and still running strong! 
    • ebinmaine
      By ebinmaine
      As if we don't live far enough out in the sticks already.
       
      We're going to go a few hours North and hang around rough camping with the moose for a few days.
       
      Can't even begin to tell you how much I'm looking forward to it!!
       
       
    • Team70R
      By Team70R
      Scored a 606 for free. Got it going tonight and there is no 3rd gear. If you force it and let off the clutch it just grinds. Any suggestions??
    • Team70R
      By Team70R
      Just picked up a free Honda g300 to shoehorn into my 606!! The only problem is it can't keep spark! When you ground the plug on the block it'll spark beautifully then all of sudden nothing. Pull the recoil start a few more times and boom, back to a great spark. Spark plug is missing the little screw on cap on the top but fits tight in the boot. Tried a different with the little cap but it won't snap in?! Would this be the cause of my problem?
×
×
  • Create New...