Digger 66 3,478 #1 Posted April 3, 2016 Made some progress over the week / weekend : Got the bracket for the belt tension lever hacked apart , re-aligned , welded back together . New axle bushings & woodruff key installed . Put a coat of paint on the body . This isn't an aesthetic resto , a mechanical one . But I just can't stand chipped old paint 1 Share this post Link to post Share on other sites
squonk 40,718 #2 Posted April 3, 2016 Nice but I think your clock needs winding. The pendulum isn't moving! 2 Share this post Link to post Share on other sites
Digger 66 3,478 #3 Posted April 3, 2016 58 minutes ago, squonk said: Nice but I think your clock needs winding. The pendulum isn't moving! Time stands still when I'm doing what I like to do 3 Share this post Link to post Share on other sites
Digger 66 3,478 #5 Posted April 9, 2016 (edited) Going to fire her up tomorrow . Anyone know if there's a correct break in oil for these ? Or are they "bench-run" at the factory . Was going to run it first with dinosaur 10-30 for a couple cycles , drain & switch to 5-30 full synthetic . Edited April 9, 2016 by Digger 66 Share this post Link to post Share on other sites
Reel Mower Freak 125 #6 Posted April 10, 2016 A new blower is pull'n go so you should be fine running it as you stated. If I can get this blower for my Raider working well I'm going to give up on the 45"MTD. It needs a rebuild or a new motor. It's been a pain since new. Share this post Link to post Share on other sites
squonk 40,718 #8 Posted April 16, 2016 Nothing like a walk behind blower that doesn't take 3 people to run it! We got a Simplicity at work that takes a P.H.D. to run it! 2 Share this post Link to post Share on other sites
Wishin4a416 2,190 #9 Posted April 17, 2016 Nice! Gonna look brand new when your done. Share this post Link to post Share on other sites
Pullstart 62,168 #10 Posted April 17, 2016 3 hours ago, squonk said: Nothing like a walk behind blower that doesn't take 3 people to run it! We got a Simplicity at work that takes a P.H.D. to run it! Didn't have to read the post to "like" it! 2 Share this post Link to post Share on other sites
Digger 66 3,478 #11 Posted May 1, 2016 Made some progress today . Going to take some brainstorming for the chute direction rod & universals . The new head is right where the old rod passed through . Share this post Link to post Share on other sites