jhardwick 6 #1 Posted March 31, 2016 Recently purchased my first Wheel horse. D160 but it is lacking a 3 point hitch and rear PTO. Has anyone ever fabricated one or the other instead of looking for a needle in a haystack? 1 Share this post Link to post Share on other sites
Retired Sparky 526 #2 Posted March 31, 2016 To You're going to like it here. 1 Share this post Link to post Share on other sites
82Caddy 851 #3 Posted March 31, 2016 Both were listed on eBay earlier today. Not cheap, but they are out there. Share this post Link to post Share on other sites
jhardwick 6 #4 Posted March 31, 2016 From the look of it its a pully ,shaft , couple of bearings and a bracket. You would think with a mig welder and a stop off at tractor supply it wouldnt be that hard. The same for the 3 point hitch. I seen one for $180 for a Kubota, with a couple of tweaks you would think it could work. ? 1 Share this post Link to post Share on other sites
82Caddy 851 #5 Posted March 31, 2016 Getting the correct spline count on the rear to use the 2000 rpm tiller could be difficult. That is unless you have plans to sort out what size pullies are needed to end up at a different rpm for the pto. Without knowing what you're trying to do we're all just guessing. 1 Share this post Link to post Share on other sites
Shuboxlover 478 #6 Posted March 31, 2016 i have a rear PTO assembly for sale in the classifieds, and part of a three point 2 Share this post Link to post Share on other sites
