E-SWEDE 4 #1 Posted August 3, 2015 My brother dropped my transmission pulley today on my RJ58, if you ask me it looks like he slammed it. Busted four large fragments off of it. So now I am in need of one part # 1611 transmission pulley. Does anyone have a spare or know of a cross reference and where I could get one? Here it is almost ready for blasting. Share this post Link to post Share on other sites
squonk 41,721 #2 Posted August 3, 2015 I'm almost thinking you could find a pulley that will work at an electric motor shop. The pulley on the engine of my RJ is a Browning brand pulley.Measure up the pulley remnants and measure the shaft. You want one for a 1/2" wide belt. Share this post Link to post Share on other sites
RedRanger 1,468 #3 Posted August 3, 2015 I had a similar misfortune with the cast double pulley on my rear discharge deck last week, except it was my fault.Couldn't find what I needed, so I ordered on-line.This place has anything and everything you want.http://www.youngsindustrial.com/List/Pulleys/V-Belt-Pulleys Share this post Link to post Share on other sites
E-SWEDE 4 #4 Posted August 3, 2015 Would a transaxle pulley off an 856 work? Same shaft size, same OD just not sure about the belt width. 1 Share this post Link to post Share on other sites
slammer302 2,156 #5 Posted August 3, 2015 i've used the pulleys from the uni drive 3speeds on my suburban fit and work fine so a 856,857,656,657 and so on will work Share this post Link to post Share on other sites
Jake Kuhn 1,556 #6 Posted August 3, 2015 Pm me, I have a couple spares. looks like your off to a good start on the rj though, look forward to seeing it come along. Share this post Link to post Share on other sites
