NA73 71 #1 Posted May 9, 2015 (edited) made some slight changes to the snow plow and snow blower (single- stage) after this past winter. made some stops out of steel tubing that telescopes to prevent the plow from bending backwards: the paddle width seemed as though it needed to be a little wider. the chute is about 7" in diameter and the new paddles are just a hair over 6": changed the angle of the chute by cutting 2" out of the back. the cut-out is on the milk crate. if need be next winter I'll extend the chute to make it a little taller. Edited May 9, 2015 by NA73 2 Share this post Link to post Share on other sites
