Toro Wheelhorse 212-5 Wiring

[Adamsminitractor 9]

Hi ya all. Just a quick question. I have just bought a Toro WH 212-5 thats a none runner. Its none runner simply because the key snapped off on the ignition switch.

But when i went to pick it up the old owner had very kindly taken out the old switch. My question is i was looking for a "block of wires" that plug onto the back of the switch, however there is not one.

There are all seperate wires with spades on them so they could go any order. The old switch has 7 posts. Can someone just post a close up photo of the back of there switch if possible, or a wiring diagram that includes ign swch please.

 

Many thanks Adam

[gwest_ca-(File Mod) 11,040]

If you go into the Manuals section here and do a search for 212-5 there are many wiring diagrams. If you have the long model number that should narrow down the possibilities.  Also post that number so we can all look at what you are doing.

 

Garry

[Adamsminitractor 9]

Thanks Gary. Is there a serial number on this like there is on my C125?? if so where would it be on this. I will have a closer look in daylight tomorrow. Thanks again

[gwest_ca-(File Mod) 11,040]

In the 1988 and 1992 operator manuals they show the tractor identification decal on the rear fender pan under the left side of the seat. Left and right always from the operator's position. If it is not there see if you can post all the numbers off the engine's data decal if there is one. Sometimes the numbers are stamped into the blower housing on a B&S. Sometimes we can ID the tractor that way.

 

Garry