mwhod 1 #1 Posted October 6, 2014 I have a c160 hydrostatic trans, yesterday i was trying to get the hub off the right side of the rear axle, i heated it best i could and tried to drive it off, apparent the snap ring that hold the axle in place slipped off and the whole shaft came out, im wondering if someone here possibly has had that problem and could advise as to the best way to go about getting it back in after i get the hub off, any help would be appreciated, mike Share this post Link to post Share on other sites
pfrederi 17,905 #2 Posted October 6, 2014 You will have to remove and split the transmission to fix it. Sorry 1 Share this post Link to post Share on other sites
pacer 3,174 #3 Posted October 6, 2014 And -- hope you didnt mangle the groove that the clip sits in :eek: Share this post Link to post Share on other sites
mwhod 1 #4 Posted October 6, 2014 that was my fear, i will inspect the groove closer, thanks for the reply Share this post Link to post Share on other sites
