km3h 543 #1 Posted September 18, 2014 I am restoring a 416-H. I have taken several hundred photos when I dismantled it but I neglected to pay attention the how the fuel line was routed from the tank to the engine. Anyone out there have any photos or a drawing or something???????? Share this post Link to post Share on other sites
Geno 1,929 #2 Posted September 18, 2014 Is a 417A the same? Share this post Link to post Share on other sites
km3h 543 #3 Posted September 18, 2014 Pretty much Gino. The only real difference is the Onan engine. Share this post Link to post Share on other sites
Martin 2,133 #4 Posted September 19, 2014 Nick, heres how i did mine. there should be a clamp at the rear upper most point of the left side of the hydro that holds it in position. i also put a clamp on top of the transmission(two bolts that go into the top to hold the seat pan support..... have to look inside here to see where it goes, this pic was taken for another reason....... 1 Share this post Link to post Share on other sites
km3h 543 #5 Posted September 19, 2014 Thanks. That will work just fine. Don't know why I did not get a photo of that. Share this post Link to post Share on other sites
