mark59200 0 #1 Posted July 11, 2014 I am redoing a K301 to put in a C120 (first timmer) my problem is crank shaft size I have an inch the PTO and engine pulley are I think is 1 1/8" obviously won't work any suggestions?? Share this post Link to post Share on other sites
jeremi3210 735 #2 Posted July 11, 2014 If it's going on a gear drive you can find a pulley off a 8hp or one off a Briggs. If it's going on a hydro the parts become a lot harder to find. I've seen adapter kits on ebay that turn a 1 inch pto into a 1 1/8, I've never tried one has anyone? Share this post Link to post Share on other sites
Don1977 604 #3 Posted July 11, 2014 (edited) That one inch shaft Kohler may not have the crank shaft bearings that one off a Wheel Horse has. Will be a problem with a manual PTO. Edited July 11, 2014 by Don1977 Share this post Link to post Share on other sites
mark59200 0 #4 Posted July 16, 2014 Thanks I will look for a 1 inch conversion or maybe do an electric pto Share this post Link to post Share on other sites
mark59200 0 #5 Posted August 31, 2014 (edited) FYI they do make a1inch x 4 inch engine pulley and a 1 inch bushing to fit a 1 1/8 (hard to find) Thanks all for your thoughts Edited August 31, 2014 by mark59200 Share this post Link to post Share on other sites
