Mr. 856 170 #1 Posted February 28, 2014 can someone remind me where the steering shaft collar ends up when installed? is it just behind the dash? I also acquired a new steering post bushing. does that go in the dash hole? Share this post Link to post Share on other sites
Terry M-(Moderator) 2,175 #2 Posted February 28, 2014 Both under the dash with the bushing in the hole first on top of the collar. Share this post Link to post Share on other sites
Mr. 856 170 #3 Posted March 1, 2014 thank you terry Share this post Link to post Share on other sites
Retired Wrencher 5,438 #4 Posted March 1, 2014 (edited) Mr 856 does this help??? there is a bushing that goes on the shaft that fits inside of console. Gary B..... CLICK ON PICK TO RIN... Edited March 1, 2014 by T1257 1 Share this post Link to post Share on other sites
Mr. 856 170 #5 Posted March 1, 2014 Yes it does!!! Thanks for taking the time and great video and tractor!! Did you get to finish it? Share this post Link to post Share on other sites
Retired Wrencher 5,438 #6 Posted March 1, 2014 Yes it does!!! Thanks for taking the time and great video and tractor!! Did you get to finish it? Thanks Mr 856 no waiting for warmer weather and a new carb and a back ordered Governor linkage. good luck with your project. Gary B..... Are u in the state of Connecticut ??? Share this post Link to post Share on other sites
Mr. 856 170 #7 Posted March 2, 2014 Yes I am and I see you are from springfield........so that puts you and I approx. 10 minutes from each other. I live in suffield. What do you need for governor linkage? Is that a Tecumseh on there? Share this post Link to post Share on other sites
Retired Wrencher 5,438 #8 Posted March 2, 2014 (edited) Yes I am and I see you are from springfield........so that puts you and I approx. 10 minutes from each other. I live in suffield. What do you need for governor linkage? Is that a Tecumseh on there? IT is a HH60 and the linkage is on the way. I hope to see @ some shows this year. There are a lot of them close buy 1hr or less. If u need help with this let me know I can get the list. Take Care Gary B................. oohh this one came out of Suffield I hated to sell it ran so smooth! But needed the room. CLICK ON PICK TO MAKE LARGER. Edited March 2, 2014 by T1257 Share this post Link to post Share on other sites
Mr. 856 170 #9 Posted March 2, 2014 I have a bag full of Tecumseh governor/throttle linkage parts for the HH60's. let me know if there is anything you may need in the future. Never been to a show. I will have to check one out this year. Share this post Link to post Share on other sites
jackhammer 546 #10 Posted March 4, 2014 T1257 I was looking at your pics of the 1057 seat . Were those tears repaired that I seen or just look that way.. Share this post Link to post Share on other sites
