dparke 16 #1 Posted November 13, 2013 Can anyone help me out with a measurement? I got a couple wheels that I was hoping to use on my RJ-58/9 project, but I think that the center hole on these wheels are way to large for the RJ spindles. Can anyone here with an RJ take a quick measurement to tell me the diameter of the spindles where they slide through the wheels? I'd measure myself, but I'm going to be away from my place for a couple days. I think I'm sunk on this one. Thanks for any help! -Dan Share this post Link to post Share on other sites
slammer302 2,156 #2 Posted November 13, 2013 I think there 3/4 Sent from my XT907 using Tapatalk Share this post Link to post Share on other sites
dparke 16 #3 Posted November 13, 2013 Thank you. That's what I was thinking. These wheels are apparently set up for a 7/8" spindle. I wonder if I can swap the bushings from my old wheels to these new wheels... Share this post Link to post Share on other sites
slammer302 2,156 #4 Posted November 13, 2013 Maybe Sent from my XT907 using Tapatalk Share this post Link to post Share on other sites
wallfish 17,494 #5 Posted November 13, 2013 Yup, RJ spindles are 3/4. You should be able to tap out the old bushings/bearings and install new ones or your used set. Share this post Link to post Share on other sites
victor3ranger 11 #6 Posted November 15, 2013 I am needing a set of front and rear wheels for my 551. Share this post Link to post Share on other sites
