k161 governor

[zanepetty 117]

This is stressing me out. Should I drill out the Welch plug? Put a hole n it and pull it out?

[rmaynard 15,458]

If you drill a hole, be careful not to go too deep. Just penetrate it. Punching would probably be safer so as not to get metal fragments.inside the block.

Edited October 27, 2013 by rmaynard

[zanepetty 117]

OK. Well if I can't penetrate the plug I guess it won't do me any good. I guess I could try to keep prying it out with a screw driver. Im just lost as to what to do.

[zanepetty 117]

I FINALLY got the plug out. What a pain. I don't see anything that would cause to jam? Anything in particular to look for while the plug is out as far as damage goes?

[rmaynard 15,458]

PM sent

[zanepetty 117]

Is there a good way to check to see if everything is alright in there? I took the retaking screw out so I want to make sure everything is in its right place. Also I had to drill a hole in the Welch plug. I tried my best to b clean about it. Do I need to drain the oil?

[JimmyJam 542]

Sorry, but the pic you posted is poor, so we can't see what we are looking at. As Bob has mentioned the retaining screw is nothing more than to secure the governor adjustment "position" on the outside. Looking into the welch plug, you should be able to see the cross shaft and tab. I would recommend replacing oil prior to firing it up again.

[zanepetty 117]

I'll take another picture then. That one does look poor. If I post it later tonight could one of u gents take a look?