simple_stan 0 #1 Posted August 1, 2013 I just got this 516H and it doesn't run. Doesn't seem as though it can't be pushed or pulled either. Am I doing something wrong. Never had a hydro that couldn't be disengaged. Any ideas? Share this post Link to post Share on other sites
Wheel Horse Kid 105 #2 Posted August 1, 2013 Have the same problem on my 518h. Not sure what to tell you on that one. Share this post Link to post Share on other sites
ericj 1,578 #3 Posted August 1, 2013 pull the belt disengage handle and push the motion control handle all the way forwards and you should be able to push it. but don't count on it. i have only ever been able to push 1 tractor like that and it had been sitting a long time. when i got it home i cranked the motor over several times by hand and that alone made it even harder to move. if it has been run at all recently you may not be able to push it. on the bright side if it can't be pushed it means that it's a good eaton 700 trans eric j Share this post Link to post Share on other sites
Kelly 1,029 #4 Posted August 1, 2013 Don't push a eaton 700, it's not good on them, and they are known for there problems to begin with, put it on something and pull it, make a skid, anything. Share this post Link to post Share on other sites
simple_stan 0 #5 Posted August 1, 2013 Thanks for all of the help. Share this post Link to post Share on other sites
