Red144runner 657 #26 Posted December 28, 2016 On 12/7/2016 at 4:59 PM, Fred Jimenez said: This page was super helpful since I needed to make a lift flag for my tractor. After I had the dimensions it only took me an hour to build. Thank you everyone. 96 t100? Share this post Link to post Share on other sites
trapper570 0 #27 Posted January 2, 2017 great info!! does anyone have the dimensions of the tall chute rotating crank support tube?? thanks for any info Share this post Link to post Share on other sites
peter lena 8,648 #28 Posted December 3, 2018 I like the lift rod and flag made by other members above, so its a doable thing, having just added pull spring mount to my lift rod, if I was going to make one I would weld on a heavy drilled pull point, on top of rod, just before the end of the curved lift /pin area. so if you wanted to make the blower lift easier you would have a place to mount springs, Pete Share this post Link to post Share on other sites
Ed Kennell 38,305 #29 Posted September 19 On 12/7/2016 at 4:59 PM, Fred Jimenez said: This page was super helpful since I needed to make a lift flag for my tractor. After I had the dimensions it only took me an hour to build. Thank you everyone. Ya may want to flip the side extensions Fred. When they are installed correctly the blower won't pull you sideways as bad. 1 Share this post Link to post Share on other sites
