855 resto.....sort of

[Buda 11]

Its gona be slow going as money it tight but here is my start

Tie Rods

Ran a die over 3/8 in cold rolled steel rod and got some tie rod ends at Farm King......I can just replace the ends if they are ever a problem again.  Still cheaper than buying new. 

Any way its a start

[AMC RULES 37,126]

Looks beefy.    

[Sparky-(Admin) 21,300]

A front end alignment is one way to start off a resto project    ..... Good luck!!

Mike............

[Buda 11]

Oh I dont know how well its aligned   but my left tie rod wont be falling off any more

[953 nut 55,032]

  Even though they a short I am not too sure 3/8 is big enough to keep from bending. You may want to consider backing them up by slipping a piece of pipe that fits snugley over them

 

between the new rod ends. You can always give what you have a try and add the pipe later if it is needed.   

 

 

[Buda 11]

953 I had the same thought that they may not be strong enough.......the pipe would take care of it for sure if they become a problem......the most weight I will have up front will be a blade for pushing snow

[KC9KAS 4,741]

If you are pushing snow and hit something frozen with one of the front wheels, you will need to work on the tie rods again!

In this case, bigger (diameter) is better!

[Howie 886]

They may be a little small but my Raider 12 has been that way for 15 to 18 years. Have never bent them, although

if something hard was hit probably would

[Buda 11]

They may be a little small but my Raider 12 has been that way for 15 to 18 years. Have never bent them, although

if something hard was hit probably would

This is what I'm hoping for.....If I bend one......well they were easy enough to make and I'll go bigger next time.

[Buda 11]

A bit of progress.

 

[Jake Kuhn 1,554]

Looking good!

[Buda 11]

The fender painted the second time.....the first time I found a hair in it and just wet sanded the whole thing and resprayed.

Edited August 25, 2013 by Buda

[Buda 11]

 

 

[Pullstart 62,758]

that's the nicest bar stool I've seen in quite some time!

 

 

 

The fender painted the second time.....the first time I found a hair in it and just wet sanded the whole thing and resprayed.

[Buda 11]

[Buda 11]

Fitting the drive belt cover.  Now I realize I should have test fit this stuff before I painted.....Oh Well.....Fender had to be massaged to fit around everything and will need some paint repair. or I will sand it again and respray....Live and learn

[Buda 11]

Clutch, brake linkage and lift handle all painted and installed.....progress

[Buda 11]

Starting on the engine.  A bit of carb cleaning and replacing of the needle and seat.

[AMC RULES 37,126]

   Some good looking  progress going on there.     

[Wishin4a416 2,191]

Looks real good! Thats one nice thing about redoing these, you can set it aside and go back to it anytime. Nice job.

[Stigian 1,234]

Nice work Sir, she's going to be beautiful when she's finished

[Buda 11]

Thanks guys.......it's a slow process, time and money

Sent from my iPhone using Tapatalk

[Buda 11]

[Molon_Labe 731]

You've got a sweet looking machine there. Nice work!!

[ben06351 19]

Looks good. Nice work.