Control arms/ Ball joint assembly

[23 Reo 229]

Does anyone know where I can get control arms/ball joint assemblies for my 72 Raider 14 

part numbers RH 102592 and LH 102593 ?  Thank you

[Shuboxlover 478]

How long are they center-center?

[gwest_ca-(File Mod) 11,029]

78-2900-01 (replaces 102592 and 102593) TIE ROD ASM still available from Toro

3 adjustable pieces now replace the original one piece

 

Garry

[Tankman 3,518]

You might try partstree.com;

http://www.partstree.com/parts/?pn=78-2900-01

Lowes and Home "Cheapo" have tie rod ends. I don't know if they're the right size.

I might take a peek-a-boo at a pair. You would then need to cut a rod and thread both ends.

http://www.appliancerepair.homedepot.com/PartDetail/Ball-Joint-Assembly/9230448A/1606406

[Buckshot 1 15]

 I buy from Mcmaster-Carr. good selection and a heck of lot cheaper them those bos stores.

[JUSS10 250]

I make my tie rods. i get rod ends from racingrodends.com then use steel tubing that i tap with a left and right hand 3/8" fine thread tap. That said, i know not everyone has the ability to do this but it is much cheaper and they look nice too!

 

Justin

[Don1977 604]

I used 1/2" heim joints with bushings to 3/8" at the spindles. Made that change around 1988 the tie rods were falling off about ever other time I mowed. Got tired of beating them back together to finish the yard.

 

[roscoemi 245]

I bought joints and rods from McMastercarr for about $50 shipped and made my own, and they are greasable.

[Duff 206]

^{Same here - I made these with parts from McMaster-Carr. Not difficult!}

 

 

 

 

 

^Duff              

Edited March 27, 2013 by Duff