coldone 35 #1 Posted November 13, 2012 This one is a little over 1 hour, Tried to shorten it up a bit but no luck. In this one, putting rotory group on, putting locking mechanism together the correct way, cleaning and more cleaning. 1 Share this post Link to post Share on other sites
Trouty56 565 #2 Posted November 13, 2012 I don't think mine is put together correctly after watching this. It works good but when I flipped the housing (the direction was wrong) the piston assembly was not attached like that. I opened my pump to regasket and it wasn't either but it may be different. I'm still having a hard time understanding how the spring works....lol.... Share this post Link to post Share on other sites
coldone 35 #3 Posted November 14, 2012 I don't think mine is put together correctly after watching this. It works good but when I flipped the housing (the direction was wrong) the piston assembly was not attached like that. I opened my pump to regasket and it wasn't either but it may be different. I'm still having a hard time understanding how the spring works....lol.... How was it attached? When you loosened your housing, did the housing get pushed out from the motor block? When you put it back on did the housing go all the way to the motor block without any resistance? When the housing is off, the spring (cylinder block) will not have any tension on it and you can push and pull the main shaft with no resistance. Once you push the shaft inward (towards the transaxle) the cylinder block contacts the valve plate. Then you have to force the shaft inwards agianst the spring pressure. When you reinstalled teh housing, it should have went on and then stop about 3/8 inch from the motor block. The screws would have started but you would not have been able to finger tighten them up all the way. The screws usaully are used to pull the housing up all the way. Hope I answered your question. The pump is different and it will be shown in a later vid. Share this post Link to post Share on other sites
Trouty56 565 #4 Posted November 14, 2012 You know I honestly don't remember.....lol....3 years ago... Share this post Link to post Share on other sites
Hoozey 2 #5 Posted May 15, 2017 will bookmark this one. thanks for sharing Share this post Link to post Share on other sites
