Tell me it aint so...

[krazy_horse 59]

My 856 was not braking to well so this a.m. I was going to adjust the band when I found freash 90wt. trans oil on the brake band and pully. It looks to be seeping between the shaft where it comes out of the tranny. I have never been inside one of these trannys but it looks like the seal will be an inside job. Is this correct? What parts will I need to have on hand? I am going to The Wheel Horse Show in June so I will leave her parked till then. Regards, Jim O yes its a 3 speed

[WH854 44]

My 856 was not braking to well so this a.m. I was going to adjust the band when I found freash 90wt. trans oil on the brake band and pully. It looks to be seeping between the shaft where it comes out of the tranny. I have never been inside one of these trannys but it looks like the seal will be an inside job. Is this correct? What parts will I need to have on hand? I am going to The Wheel Horse Show in June so I will leave her parked till then. Regards, Jim O yes its a 3 speed

It's been done from the outside you have to take the break drum off

Chas

[WH854 44]

Seals for it

3/4 " Brake Shaft 100441 C/R 7410

1" Axle -Old Brake Shaft 1232 C/R 9815

5/8 (.625) Input Shaft 100442 C/R 6105

1-1/8" Axle 100443 C/R 11050

[krazy_horse 59]

You guys made my day. Thanks so much for the info. and part numbers. Thanks again. Regards, Jim

[krazy_horse 59]

Supporter listed the number of a one inch old brake shaft seal as #1232 cr 9615. The local NAP say they cannot find this number. Any one have a cross refferance number? The tractor is a 856 with a three speed. Thanks jim

[racinfool40 202]

The new Toro # is 100863 which is the same for the 1" axle seal and can be used for both the 1" axle and the 1" brake shaft.

MIKE

[pfrederi 17,885]

Supporter listed the number of a one inch old brake shaft seal as #1232 cr 9615. The local NAP say they cannot find this number. Any one have a cross refferance number? The tractor is a 856 with a three speed. Thanks jim

Maybe because the # is 9815 not 9615 as you typed above

[krazy_horse 59]

Thanks Mike, I called Napa back and gave them the number you gave and the seal will be here in a.m. Yes, I am bad about hitting the wrong key and transposing numbers but I"m and old guy!!