Butch 194 #1 Posted August 17, 2011 I'm putting my snow plow together that's been laying around 5 years and can't figure out where a heavy wire goes. There are 2 of them. One goes to the pin to release the plow for turning and the other has about a 5" bar/rod at the end that I can't figure out where it goes. Can anyone help me. I could take a picture if needed. Thanks. Share this post Link to post Share on other sites
rmaynard 15,308 #2 Posted August 17, 2011 Are you sure on that number (641136), or could it be a 6-4113 6? http://www.mywheelhorse.com/graphics/file/...rame_6-4113.pdf Share this post Link to post Share on other sites
Butch 194 #3 Posted August 17, 2011 Are you sure on that number (641136), or could it be a 6-4113 6? http://www.mywheelhorse.com/graphics/file/...rame_6-4113.pdf Bob the part number was like this 6-4113-6. The manual you gave me was the correct one. But it doesn't show me where part number 26 goes, the assembly lever. Thanks for the manual! Share this post Link to post Share on other sites
rmaynard 15,308 #4 Posted August 17, 2011 Waiting for RedSquare tonight is like watching paint dry. By the time I get to post this, you will have figured it out. Anyway, part #26 is attached just about 4 inches below the top of lever #23. If you look, you will see a hole. Share this post Link to post Share on other sites
Butch 194 #5 Posted August 17, 2011 Thanks again Bob! Does itgo on the front side or back side? Thanks again Share this post Link to post Share on other sites
rmaynard 15,308 #6 Posted August 17, 2011 You want to mount it so that when you grip the lever, you are pulling it toward you. So I guess that means that it mounts on the front side of the arm. I can take a picture of mine if you need it. Share this post Link to post Share on other sites
Butch 194 #7 Posted August 17, 2011 Got it. Thanks! Share this post Link to post Share on other sites