dmac 0 #1 Posted April 22, 2011 Any tips on probable cause and possible part replacement(i.e., seal/bearing) etc?? And where to find Parts?? :thumbs: Share this post Link to post Share on other sites
rmaynard 15,603 #2 Posted April 22, 2011 :thumbs: What year is your 310-8? Three possible places to look. Input shaft seal, brake shaft seal, or axle seals. If you don't have any up and down motion in the axles, it's probably the seals. All seals are available from Toro or your local NAPA auto parts store, and are replaceable without opening the transmission. Share this post Link to post Share on other sites
JimD 3,345 #3 Posted April 26, 2011 Why is this thread in the vendors section? :thumbs: Share this post Link to post Share on other sites
can whlvr 993 #4 Posted April 29, 2011 i just did my c101 seals,i recommend that you do them all if you do them,they will all be ready to leak if one is,its not too bad as long as you can get the hubs off,i built a puller out of angle iron to do this Share this post Link to post Share on other sites
