wheelhorse416 0 #1 Posted January 30, 2011 Hi, Guys i'm a newbie to the red square. My Good Friend TMIX got me hooked!!! He came down this afternoon, i seem to be missing the pin that is suppose to be on the back of the frame of the plow. That hooks to the rear axle, not sure what it looks like. Maybe someone could show a pic?? I am guessing 3/4" round stock pinned on the ends :banghead: Share this post Link to post Share on other sites
Lane Ranger 10,968 #2 Posted January 30, 2011 Wheelhorse 416: Here are some photos of the "bar" or 3/4 inch rod that goes on the back of a snowplow frame. This rod has two puch pins in it allowing it to be moved on the frame. These are on the short/long frames -allowing for use on several different model tractors. This is a 54" snowplow used on a 1964 Wheel Horse 1054 tractorwith a "fixed" rod that does not move. P.S. TSC -Tractor Supply has 3/4 inch rods in their hardward section that would work for you. :banghead: Share this post Link to post Share on other sites
wheelhorse416 0 #3 Posted January 30, 2011 Thank_You !! That was Fast! 3/4 inch pin you say looks like you have a spare?? Thank You very much :banghead: Share this post Link to post Share on other sites
Lane Ranger 10,968 #4 Posted January 30, 2011 No - I sold that plow last Fall for $95 to a Red Square member needing a plow.! Share this post Link to post Share on other sites
Sparky-(Admin) 21,319 #6 Posted January 31, 2011 :thumbs: Sounds like Lane Ranger has you all straightened out . Mike......... Share this post Link to post Share on other sites
racinfool40 202 #7 Posted January 31, 2011 :thumbs: Hooked you say, it's just the beginning!! Have fun !!!! :banghead: Share this post Link to post Share on other sites
AMC RULES 37,130 #8 Posted January 31, 2011 :thumbs: 416 :banghead: Share this post Link to post Share on other sites
tmix 34 #9 Posted January 31, 2011 About time Get that wheelhorse a plowing boy tmix Share this post Link to post Share on other sites
Arndts small engine repair 0 #10 Posted January 31, 2011 Hi :banghead: Share this post Link to post Share on other sites
Roger from southern Iowa 1 #11 Posted January 31, 2011 :banghead: Share this post Link to post Share on other sites
bitten 134 #14 Posted February 1, 2011 Hello and :banghead: Share this post Link to post Share on other sites
JC 1965 1,530 #16 Posted February 1, 2011 :banghead: Hello, you'll like it here !! Share this post Link to post Share on other sites
can whlvr 993 #18 Posted February 2, 2011 :banghead: Share this post Link to post Share on other sites
Kelly 1,029 #20 Posted February 2, 2011 :banghead: You can buy the 3/4" round stock at most hardware stores or TSC, but a welding shop might have it also and be cheaper. Share this post Link to post Share on other sites
wheelhorse656 20 #21 Posted February 2, 2011 :banghead: Share this post Link to post Share on other sites
