the WHEEL HORSE logo on the front

[Redbirdman 7]

Any tricks for painting the WHEEL HORSE logo on the front of the early model hoods?...........

Ed

[VinsRJ 723]

A very steady hand. Caffeen prior to the project is a no, no :ychain:

[mavfreak 11]

But a beer might steady it up :ychain:

[Ken B 3,165]

A few beers before painting always helps for me! :ychain:

[buckeye 5]

that's how i did mine. freehand with a good detail brush. Oh, and :ychain:

[Lane Ranger 11,061]

I used the Elmer's White paint pen and you can buy it in fine or regualr tip.

It worked great on my Lawn Ranger embossed hood.

Also works good on the Kohler embossed logo on Kohler motor covers.

http://www.amazon.com/Elmers-Painters-Opaq...r/dp/B000BRFDVS

:ychain:

[Kelly 1,030]

I used a white paint pen also two coats and done, works nice.

[MikesRJ 552]

This may help as well ...

http://www.mywheelhorse.com/modules.php?na...o=show_doc&id=1

[JMW 3]

I have used rubber cement to cover the entire word.Just trim around the letters and then paint.when it's done drying just rub the cement off.

[andrewick 0]

I had my very talented mother paint the lettering on mine. She used a brush to apply the paint and then for the clean edge she used a tooth pick to push the paint to the edge. check it out here. she did my kohler motors and my rj58. the 753 was done when i got it and not as good as Mom did. http://www.flickr.com/photos/wickershamwed...57621687315124/ sorry for long address.

[rickv1957 72]

Them paint pens work great!!!

[squonk 41,840]

I have used rubber cement to cover the entire word.Just trim around the letters and then paint.when it's done drying just rub the cement off.

Yup ,that's the way to do it!

[buckrancher 2,694]

I use a tester's gloss white paint pen it uses a 1/8" wide wedge shaped

tip

you can get them at hobby & craft stores

Brian

[mavfreak 11]

the white pain't maker seams to be a rally good idea. never thought of using one of those