Snow plow for my C-120!?

[CTPATRIOT 12]

I have an early long snowplow frame from a 953.(pics)It doesn't seem to fit this tractor(center hookup in wrong place ect..),does anybody have a pic of the correct frame i need?Also,is this the correct hitch for the rear?

[Kelly 1,029]

I believe that frame is for a short frame tractor not your 953

[CTPATRIOT 12]

The frame is 61" from the mounting pin to the pivot bolt.I thought the short frames were 56".I removed this from a 953 myself.

[T-Mo-(Moderator) 4,494]

Try this link: The Long and Short of It It's a good thread on snow plows and frames needed.

[CTPATRIOT 12]

Try this link: The Long and Short of It It's a good thread on snow plows and frames needed.

That's where i got my info.I'm not sure what to do???

[jasoncracer 0]

The only thing i see wrong minus a short frame plow is all my plow brackets the bolts go upwards and nuts are on top of the rear axle!

[CTPATRIOT 12]

It's not a short frame plow.Also,the rear hitch was bolted up exactly how it came off.I believe the rear hitch that bolts from the top is a little different.(anybody have pics of different ones?)

[Rollerman 290]

You have the rear hitch on correct for that type of snow plow frame.

It won't work if your trying to lift off the T bar, but you should be able to reach the bell crank/lift mechanism on the tractor.

Can you run a length of chain from the C's bell crank down to the plow frame lift point?

If you are haveing interfearance try makeing a solid link & putting a dog leg bend in it, or make a new lifting point on the plow with some scrap metal bolted or welded into place.

The later style plows for the C's swept back & then straightened out.

The hitch like Jason mentioned also went below the axle.

They all hook on the 3/4 rod from the inside of the frame where the old ones went to the outside.

[CTPATRIOT 12]

Thanks Rollerman.I think i'll just keep this plow setup for the 1054 and get another for this tractor.I have 2 of these older style setups.