bitten 134 #1 Posted January 3, 2010 Replacing the rear end on my D200. I need the O-rings that go between the manifold and pump. $35.18 plus shipping seems very high to me for 11 o-rings. Is there an alternative to using the Toro rings? I do remember reading something about these rings before but cant remember were or what. CRS Any help would be very much appreciated, P.J. Share this post Link to post Share on other sites
pfrederi 17,866 #2 Posted January 3, 2010 I bought the rings from Toro. I have one of those 1000 ring sets and they were not included. They are 1/16" thick but fairly large diameter. There are also square profile backer rings. I looked at Mc Masters who had rings but you had to buy a package 50 or 100. If you have a really good hardware/Auto[arts store you might get lucky, but I doubt they would have the square profile backer rings. Incidentally you also will need a sealing washer for one of the bolts on the hydro motor (102817) NLA from Toro. I am using a copper washer...so far so good.... I have a couple of spare O rings out in the shop, it is 10 degrees and 20 mph wind right now so it will be a while before I go out there When I do I will try to remember to measure them for you...but no promises as I also have CRS syndrome Edit...I think you need 13 rings to do both the pump and motor ends of the manifold...just 7 for the motor end. Share this post Link to post Share on other sites
rickv1957 72 #3 Posted January 3, 2010 PJ was you able to get the rear end from Rob,toro is the best place for the correct O rings,Rick Share this post Link to post Share on other sites
bitten 134 #4 Posted January 4, 2010 Sure did Rick, thanks for the lead. Share this post Link to post Share on other sites
